Deep Blue BlueFox Basic Provozní pokyny stáhnout pdf (Strana 17)

y Ensure that the plug on the pool sensor cable is dry.

y Connect the pool sensor cable to the alarm box and

screw tight 3.

y If the pool sensor cable is too short: use an extension

cable (see Optional Accessories, P. 46).

Fig. 5 Connecting the pool sensor to the alarm box

y Check the position of the pool sensor, see Testing active mode, P. 30.

y If test fails: Check the position of the pool sensor and test again.

Following successful test:

y Mark the position of the pool sensor in the swimming pool.

y Take the pool sensor out of the water.

y Loosen the screws 4.

y Remove the mounting ring 5.

Fig. 6 Removing the mounting ring

y Read the instructions for use and the safety datasheet for the adhesive.

y Apply a thin layer of the supplied adhesive to the hollow on the rear of the

mounting ring (surface A).

y Within 6 minutes, afx surface A of the mounting ring to the marked position in

the swimming pool. Align the cable slot 6 in the desired direction.

y Do not apply any loads to the mounting ring for 24 hours.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Žádné komentáře

Deep Blue BlueFox Basic Provozní pokyny Strana 17